Epson 500DN Roll Media Instructions
Epson 500DN - B Color Inkjet Printer Manual
 |
UPC - 010343870048
View all Epson 500DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Epson 500DN manual content summary:
- Epson 500DN | Roll Media Instructions - Page 1
converter and connect the B-500 Series printer to it to protect the printer's 120VAC power supply. • Set up the printer and install its software as described on the Start Here sheet that came with the printer. Print a test page on sheet paper to ensure that the printer is set up correctly before - Epson 500DN | Roll Media Instructions - Page 2
edge 2. Feed the end of roll media into the manual feed slot at the back of the printer. Looking down from above, align the left edge of of paper 3. Guide the media straight into the slot until you hear the printer feed motor. Hold the media in place for 3 seconds or until the printer feeds it - Epson 500DN | Roll Media Instructions - Page 3
(paper path of the roll media feeding system). Adjust the media position, if necessary. 5. Send your roll media print job as described in your RIP software documentation or your printer documentation. Note: If you need to cancel a print job, first cancel any queued print jobs using the Windows Print - Epson 500DN | Roll Media Instructions - Page 4
Troubleshooting You see a LOAD CORRECT PAPER error message on the printer's LCD screen Your RIP software settings may be incorrect for your print job. Do the following to cancel any print jobs, fix the error, and continue printing: • First cancel any queued print jobs using the Windows Print Monitor
-
1 -
2 -
3 -
4
 |
 |
Using the Epson B-500 Series With
Roll Media
Before You Begin
Before printing on roll media with the Epson B-500 Series printer, make sure to do the following:
•
Check the environmental specifications that came with your printer, roll media feeding equipment, and roll media, and
set up the system in an area that complies with these conditions. Operate and store the printer and roll media in a
dust-free area.
•
If the power source in your area is 220V, install an appropriate step-down converter and connect the B-500 Series
printer to it to protect the printer’s 120VAC power supply.
•
Set up the printer and install its software as described on the
Start Here
sheet that came with the printer. Print a test
page on sheet paper to ensure that the printer is set up correctly before you proceed.
•
Remove the duplex unit from the back of the printer using the buttons on the side of the duplex unit. See your printer
documentation for details.
•
Set up your roll media feeding equipment as described in the documentation that came with it.
•
Install your RIP (Raster Image Processing) software as described in the documentation that came with it.
Precautions for Using Pre Die-Cut Media Rolls
Load
ONLY
pre die-cut media rolls with no exposed backing or liner surface, and do not remove the liner surface from the
media before loading. Also make sure the die-cut holes are on the left side of the media roll (as it loads into the printer).
Die-cut holes
on left
No
liner surface
exposed
Feed this end into printer
Caution:
Do not
load pre die-cut media rolls
with exposed backing or liner surface
or the labels may peel off during
printing and damage the inside of your
printer.