Epson 4800 Quick Reference Guide
Epson 4800 - Stylus Pro ColorBurst Edition Color Inkjet Printer Manual
 |
UPC - 010343866850
View all Epson 4800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Epson 4800 manual content summary:
- Epson 4800 | Quick Reference Guide - Page 1
EPSON® Epson Stylus® Pro 4800 QUICK REFERENCE GUIDE - Epson 4800 | Quick Reference Guide - Page 2
, remove the gray adapters from the paper stops at each end. See your Printer Guide for details. 2 Position the roll as shown, then slide it onto the appears. Alignment mark The printer automatically feeds the paper to the printing position. 10 Raise the roll paper support on top of the paper - Epson 4800 | Quick Reference Guide - Page 3
Loading Paper in the Tray Make sure the printer is on and roll paper is not loaded for surface to even the pages. 7 Flip down the paper guide roller, then replace the paper tray cover and adjust its length. Note: Make sure the roll paper support is not raised. 8 Press the Paper Source button until - Epson 4800 | Quick Reference Guide - Page 4
the top cover. 4 Insert the sheet face-up. Align paper with line next to arrow mark. 7 Return the paper lever to the secured position. The printer grabs the paper and feeds it into printing position. 8 Extend the paper tray and cover to support the sheet as it comes out of the - Epson 4800 | Quick Reference Guide - Page 5
to confirm the setting. 8 Press the Pause button. Note: You can manually run a cleaning cycle by pressing the Menu button and holding it for more than these steps to align the print head: 1 Make sure the printer is turned on. Then load Epson Enhanced Matte or Premium Luster Photo Paper. 2 Press the - Epson 4800 | Quick Reference Guide - Page 6
OUT is displayed on the LCD panel, the cartridge is empty. To replace the cartridge, first make sure the printer is on. 1 Press the ink compartment cover to open it. 2 Raise the ink lever to the unlocked position. Replacing Ink Cartridges When the ink light flashes, one of the indicators is low, and - Epson 4800 | Quick Reference Guide - Page 7
lever to its locked position. 7 If you're using 110 ml cartridges, close the ink compartment cover. If you're using 220 ml cartridges, you'll have to leave the cover open. Replacing Printer Parts Replacing the Cutter Blade If you notice that the paper isn't cut cleanly, you may need to replace - Epson 4800 | Quick Reference Guide - Page 8
Printer Parts (continued) 5 Hold down the side pin, as shown, then turn the latch to the right. Replacing the Maintenance Tank You need to replace the Maintenance Tank (part # C12C890191) when you see MNT TNK FULL on the LCD display. The ink Do not tip the tank, or ink may spill out. 2 Place the - Epson 4800 | Quick Reference Guide - Page 9
messages, see your Printer Guide. Message INK LOW INK OUT CHANGE PAPER TYPE Light Ink light flashing Ink light on Paper light on LOAD PAPER SET PAPER LEVER RELOAD PAPER Paper light on Paper light on MNT TNK FULL Ink light on Explanation Response Ink cartridge(s) are nearly empty (printing - Epson 4800 | Quick Reference Guide - Page 10
-1305. Go to http: //support.epson.com to download drivers, access product documentation and troubleshooting, and get technical advice through e-mail. Contact the RIP manufacturer. Epson and Epson Stylus are registered trademarks of Seiko Epson Corporation. Epson UltraChromeK3 and UltraSmooth are - Epson 4800 | Quick Reference Guide - Page 11
Control Panel Lights and Buttons Power button Pause light and button Hold for 3 seconds to cancel a print job or reset the printer. Ink light Left arrow or Paper Source button Hold for 3 seconds to cut roll paper after printing. Menu button Hold for 3 seconds to clean the print
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
 |
 |
Epson Stylus
®
Pro 4800
QUICK REFERENCE GUIDE
EPSON
®