Dell W-Series 324 AP-320-MNT-T Ceiling Tile Mount Kit Installation Guide
Dell W-Series 324 Manual
View all Dell W-Series 324 manuals
Add to My Manuals
Save this manual to your list of manuals |
Dell W-Series 324 manual content summary:
- Dell W-Series 324 | AP-320-MNT-T Ceiling Tile Mount Kit Installation Guide - Page 1
AP-320-MNT-T Ceiling Tile Mount Kit Installation Guide Introduction The AP-320-MNT-T Ceiling Tile Mount screw M4-0.7x6 Phillips head screw (x2) M4 hex nuts (x5) M4 washers (x5) Support box Metal eye bolt Installing the AP-320-MNT-T Ceiling Tile Mount Kit 1. Remove the ceiling tile into - Dell W-Series 324 | AP-320-MNT-T Ceiling Tile Mount Kit Installation Guide - Page 2
faceplate Unlocked position 2 1 Locked position 2 2 7. Install the support box by sliding the screw posts through holes indicated in Figure 3. posts into the support box. After tightening, check that the ceiling tile is firmly fixed between the faceplate and support box before continuing to - Dell W-Series 324 | AP-320-MNT-T Ceiling Tile Mount Kit Installation Guide - Page 3
into a solid surface above the access point's mounted location. Use a metal cable (not included) to secure support box to the eye bolt, leaving enough slack so that the ceiling tile rests flat against the ceiling grid. original position. 3 AP-320-MNT-T Ceiling Tile Mount Kit | Installation Guide - Dell W-Series 324 | AP-320-MNT-T Ceiling Tile Mount Kit Installation Guide - Page 4
4 AP-320-MNT-T Ceiling Tile Mount Kit | Installation Guide
AP-320-MNT-T Ceiling Tile Mount Kit
Installation Guide
0511837-03 |
September 2015
1
Introduction
The AP-320-MNT-T Ceiling Tile Mount Kit allows 320 Series access points to be securely mounted into an
overhead ceiling tile.
Package Contents
Faceplate
Metal bracket
M4-0.7x18 Phillips head screw
M4-0.7x6 Phillips head screw (x2)
M4 hex nuts (x5)
M4 washers (x5)
Support box
Metal eye bolt
Installing the AP-320-MNT-T Ceiling Tile Mount Kit
1.
Remove the ceiling tile into which the access point will be installed.
2.
Cut a 220mm x 220mm square hole into the center of the ceiling tile. The hole will be wide enough to fit
the screw posts on the faceplate, but does not exceed the diameter of the faceplate.
3.
Fit the screw posts of the faceplate into the ceiling tile, so that the screw posts are oriented upward
when the tile is replaced.
4.
Fit the back panel of the access point into the opening on the faceplate until all sides are flat against the
device, as shown in
Figure 1
.
Figure 1
Fitting faceplate to access point (ceiling tile not shown)