Dell W-Series 304 300 Series Regulatory Compliance and Safety Information Guid

Dell W-Series 304 Manual

Dell W-Series 304 manual content summary:

  • 1
  • 2
  • 3
  • 4

Dell Networking 300 Series Access Points
Regulatory Compliance and Safety Information Guide
0511935-01 |
September 2016
1
Introduction
This document contains domestic and international regulatory compliance and safety information for Dell Networking 300 Series access points (W-AP304,
W-AP305, W-IAP304 and W-IAP305). To ensure that this device complies with the regulatory standards for your region, please refer to the sections below.
Electrical and Environmental Specifications
Regulatory Information
Proper Disposal of Dell Equipment
Electrical and Environmental Specifications
For additional specifications on this product, please refer to the product data sheet at
dell.com
Electrical
Ethernet:
One 100/1000 Base-T auto-sensing Ethernet RJ45 interface
Power over Ethernet IEEE 802.3at 56VDC (nominal) and 802.3af 48VDC (nominal).
Power:
Maximum (worst-case) power consumption: 13W (PoE) or 11W (DC)
Excludes power consumed by external USB device (and internal overhead); this could add up
to 6.5W (PoE) or 5.5W (DC) for 5W/1A USB device
Direct DC source: 12Vdc nominal, +/- 5%
Power over Ethernet (PoE): 802.3at and 802.3af complaint source
Connect only to IEC 60950-1 or IEC 60601-1 3rd edition products and power sources.
Environmental
Operating:
Temperature: 0
°
C to +50
°
C (+32
°
F to +122
°
F)
Humidity: 5% to 93% non-condensing
Storage and transport:
Temperature: -40
°
C to +70
°
C (40
°
F to +158
°
F)
Regulatory Information
The following regulatory model names apply to the 300 Series access points:
W-AP304/W-IAP304: APIN0304
W-AP305/W-IAP305: APIN0305
CAUTION:
All Dell access points should be professionally installed by a certified technician. The technician is responsible for ensuring that
grounding is available and meets applicable national and electrical codes.
ATTENTION:
Tous les points d'accès Dell doivent impérativement être installés par un professionnel agréé. Ce dernier doit s'assurer que
l'appareil est mis à la terre et que le circuit de mise à la terre est conforme aux codes électriques nationaux en vigueur.
NOTE:
If a power adapter other than the Aruba-approved adapter is used in the US or Canada, it should be NRTL listed, with an output rated
12Vdc, minimum 2A, marked “LPS” and “Class 2”, and suitable for plugging into a standard power receptacle in the US and Canada.
NOTE:
For country specific restrictions and additional regulatory and safety guidelines, refer to the
Dell Networking W-Series Safety,
Environmental and Regulatory Information
document included with Dell controllers and Instant access points.