Dell W-Series 277 AP-270-MNT-H1 Horizontal Mounting Kit Installation Guide

AP-270-MNT-H1 Mounting Kit

Installation Guide

0511508-02 |

December 2014

1

Package Content



Horizontal Mounting Bracket x 1



Mounting Holder x 1



M10x30 Screw (with washer) x 1



M10 Nut x 1



M6x20 Screws x 3



60cm Cable Tie x 1



6 inches Hose Clamps x 2



Mounting Template



Installation Guide (this document)

Figure 1

Horizontal Mounting Bracket and Mounting Holder

Installation for 274/275 AP Models

Mounting the AP to a Ceiling

1.

Use the mounting template provided in the AP-270-MNT-H1 package to mark the four mounting

points on the ceiling.

2.

Use a drill to make four holes on the four markings from the previous step.

3.

Insert an anchor bolt into each drilled hole. Anchor bolts are not included in the package.

4.

Place the mounting bracket over the anchor bolts and press the bracket against the ceiling.

5.

Place the washers and nut onto the bolt’s threaded end and tighten the nut until the mounting

bracket is firmly attached to the ceiling as shown in

Figure 2

.

The AP-270-MNT-H1 mounting kit supports multiple access point (AP) models. To ensure proper installation,

refer to the appropriate section in this document corresponding to your AP model.

Mounting Holder

Mounting Bracket