Dell W-Series 205H AP-205H-MNTR Desk Mount Kit Installation Guide

205H-MNTR Desk Mount Kit

Installation Guide

0511761-03

|

March 2015

1

Package Contents



AP Back Cover



Mount Base



(x1) 7mm Phillips Head Screw



(x1) T8H Torx Security Screw (for optional use)



5cm Ethernet Cable



(x2) 12mm T8H Torx Security Screw



205H-MNTR Desk Mount Kit Installation Guide

Introduction

The 205H-MNTR Desk Mount Kit is a stand-alone mount for the 205H access point, equipped with an

Ethernet cable which allows access to the E0 uplink port on the bottom of the access point (E0/PT port)

when the desk mount is attached to the access point (AP).

Installing the AP-205H-MNTR

1.

Set the mount base on a flat surface, aligning the circular cutout at the top, with the corresponding

indentation at the bottom of the AP back cover. Attach the two pieces by pressing the access point back

cover onto the base (see

Figure 1

).

2.

Turn the mount upside down and insert the 7mm Phillips head screw into the hole at the center of the

base, then tighten until the AP back cover is securely fastened to the base.

The 7mm T8H Torx security screw provided may be used in place of the Phillips head screw in Step 2.