Dell W-Series 205H AP-205H-MNT2 Wall Mount Kit Installation Guide

205H-MNT2 Wall Mount Kit

Installation Guide

0511763-03

|

March 2015

1

Package Contents



Dual Gang Wall Mount



(x4) #6-32 Machine Screws



Plastic Front Cover



(x2) T8H Torx Security Screw



205H-MNT2 Wall Mount Kit Installation Guide

Introduction

The 205H-MNT2 Wall Mount Kit provides a secure and practical solution for mounting the 205H access

point to single and dual gang wall boxes.

Installing the 205H-MNT2 Wall Mount Kit

Use the following instructions to install the 205H-MNT2 Wall Mount Kit.

1.

If the wall box is not already exposed, unscrew and remove the existing wall plate, as shown in

Figure 1

.

Figure 1

Removing Existing Wall Plate

2.

Detach any RJ-45 cables by unclipping the connectors from the wall plate, or cutting/removing the UTP

cable(s).

3.

Use a short Ethernet cable (sold separately, part number AP-CBL-ETH10) to connect the E0 port to an

RJ-45 connector, or crimp an RJ-45 plug (not supplied) to the cable, and insert into the E0 port. Do the

same for the PT port if used.