Dell W-7205 SPR-RK3-MNT Installation Guide

Dell Networking SPR-RK3-MNT

Installation Guide

0511709-02 | April 2015

1

This document provides installation instructions for standard front-rack mounting the Dell W-7024/W-7205

controller in a standard two-post 19" Telco rack using the SPR-RK3-MNT accessory kit.

The W-7024/W-7205 controller is referred to as "device” in rest of the document.

Package Contents



Two rack mount brackets



Eight M4 x 8 mm Phillips Flat Head screws



Four M6 x 15 mm Phillips Pan Head screws



Four M6 cage nuts



Four M6 clip nuts



Installation Guide (this document, printed)

Standard Rack Mount Installation

This option allows mounting the device from the front in a standard two-post 19” Telco rack.

Required Tools and Equipment



Two rack-mount brackets



Eight M4 x 8 mm Phillips Flat Head screws



Four M6 x 15 mm Phillips Pan Head screws



Four M6 cage nuts (optional)



Four M6 clip nuts (optional)



Suitable screwdrivers (not included in this kit)

Installation Steps

To install the device in a two-point 19” (48.26 cm) rack system:

1.

Place the mounting brackets over the mounting holes near the front on either sides of the device (see

Figure

1

).

NOTE:

Some racks require screws that differ from those included with the device. Confirm that you have the correct screws

before installing the device.

CAUTION:

Each device should have its own mounting equipment. Do not place other networking equipment directly on top of a

mounted device. Failure to do so can result in damage to the device.

NOTE:

The figures in this document illustrate the installation procedure for the W-7205 controller. The same installation procedure

applies to the W-7024 controller.