Dell W-7030 MNT-19 Mounting Kit Installation Guide

Dell Networking W-7030-MNT-19

Installation Guide

0511666-02

| February 2015

1

This mounting kit allows mounting the W-7030 controller in a two-post 19-inch Telco rack or on a wall.

Package Contents



Two Mounting Brackets



Eight M3 x 6.5 mm Phillips flat head screws



Four M6 x 15 mm Phillips pan head screws



Four M6 Cage Nut



Four M6 Clip Nut



Installation Guide (this document, printed)

Rack Installation

Required Tools and Equipment

The following tools and equipment are required for installing a W-7030 controller:



Mounting bracket (x2)



Screws for mounting bracket (x8): M3 x 6.5 mm Phillips flat head screws



Screws for system rack mount (4x): M6 x 15 mm Phillips pan head screws



M6 cage nut (x4): Optional



M6 clip nut (x4): Optional



Suitable screwdrivers for all screw types provided in the box (not included in the package)

Installation Steps

To install a W-7030 controller into a two-post 19-inch Telco rack:

1.

Place the mounting bracket over the mounting holes on the controller (see

Figure 1

).

2.

Secure the bracket to the controller using the eight screws for the mount bracket (four per bracket) and a

suitable screwdriver.

CAUTION:

Each W-7030 controller should have its own mounting equipment. Do not place other networking equipment directly

on top of a mounted W-7030 controller. Failure to do so can damage the device.

NOTE:

Some racks require screws that differ from those included with the W-7030 controller. Ensure that you have the correct

screws before installing the W-7030 controller.