Dell W-7024 SPR-WL2-MNT Installation Guide

Dell Networking SPR-WL2-MNT

Installation Guide

0511741-01

| February 2015

1

This document provides installation instructions for mid-rack mounting and wall mounting the Dell W-7024/W-

7205 controller using the SPR-WL2-MNT accessory kit.

The W-7024/W-7205 controller is referred to as "device" in rest of the document.

Package Contents



Two mid-mount brackets



Two wall-mount brackets



Eight M4 x 8 mm Phillips flat head screws



Four M6 cage nuts



Four M6 clip nuts



Installation Guide (this document, printed)

Mid-Mount Rack Mounting

This option allows mounting the device from the middle in a standard two-post 19" Telco rack.

Required Tools and Equipment



Two mid-mount brackets



Eight M4 x 8 mm Phillips flat head screws



Four M6 x 15 mm Phillips pan head screws (not included in this package, included in the device package)



Four M6 cage nuts (optional)



Four M6 clip nuts (optional)



Suitable screwdrivers (not included in this package)

Installation Steps

To install the device in a two-point 19” (48.26 cm) rack system:

1.

Place a mid-mount bracket over the mounting holes on either side of the device in the middle (see

Figure 1

).

NOTE:

The figures in this document illustrate the installation procedure for the W-7205 controller.The same installation procedure

applies to the W-7024 controller.

NOTE:

Some racks require screws that differ from those included with the device. Confirm that you have the correct screws

before installing the device.

CAUTION:

Each device should have its own mounting equipment. Do not place other networking equipment directly on top of a

mounted device. Failure to do so can result in damage to the device.