Dell W-7005 MNT-19 Mounting Kit Installation Guide

Dell Networking W-7005-MNT-19 Mounting Kit

Installation Guide

0511738-03

| March 2015

1

This document provides installation instructions for mounting the W-7005 controller in a two-post 19-inch Telco

rack.

Package Contents



Rack mount tray



Four M3 x 5 mm flat head screws



Four M6 x 15 mm Phillips pan head screws



Four M6 Cage Nut



Four M6 Clip Nut



Installation Guide (this document, printed)

Rack Mount Installation

This mounting option allows mounting the W-7005 controller in a two-post 19-inch Telco rack.

Required Tools and Equipment

The following tools and equipment are required for installing a W-7005 controller:



Rack mount tray (x1) for rack mount installation



M3 x 5 mm flat head screws (x4) for securing the controller on the rack mount tray



M6 x 15 mm Phillips pan head screws (x4) for rack mount



M6 cage nut (x4): Optional



M6 clip nut (x4): Optional



Suitable screwdrivers for all screw types provided in the box (not included in the kit)

Installation Steps

To install a W-7005 controller into a two post 19-inch rack:

1.

Route and secure the DC power cable correctly into the slot provided at the bottom of the controller. See

Figure 1

.

2.

Place the controller on the rack mount tray such that the DC cable is not obstructed. See

Figure 2

.

NOTE:

Some racks require screws that differ from those included with the W-7005 controller accessory kit. Ensure that you have

the correct screws before installing the W-7005 controller.