Dell DAE2 Setup Guide

Dell DAE2 Manual

Get Dell DAE2 PDF manuals and user guides View all Dell DAE2 manuals
Add to My Manuals
Save this manual to your list of manuals

Dell DAE2 manual content summary:

  • Dell DAE2 | Setup Guide - Page 1
    EMC 2-Gigabit Disk Enclosure (DAE2) SETUP GUIDE P/N 014003104 REV A01 EMC Corporation 171 South Street Hopkinton, MA 01748-9103 Corporate Headquarters: (508) 435-1000, (800) 424-EMC2 Fax: (508) 435-5374 Service: (800) SVC-4EMC
  • Dell DAE2 | Setup Guide - Page 2
    OR FITNESS FOR A PARTICULAR PURPOSE. Use, copying, and distribution of any EMC software described in this publication require an applicable software license. Trademark Information EMC2, EMC, CLARalert, CLARiiON, and Navisphere are registered trademarks and Access Logix, ControlCenter, MirrorView
  • Dell DAE2 | Setup Guide - Page 3
    you will need to get one or more 2-Gigabit Disk Array Enclosures (DAE2s) up and running. It assumes you are configuring the 3U enclosure as a disk array for a storage processing device (such as an EMC SPE with storage processors). Refer to this guide as you perform the following tasks: • Set
  • Dell DAE2 | Setup Guide - Page 4
    EMC Storage Systems 40U Cabinet Configuration Guide (P/N 014003082) ❑ Fibre Channel copper cable for connecting the DAE2 to a storage processor device (1 per connection) ❑ Copper cables for connecting multiple DAE2s to each other (2 per DAE2) ❑ EMC 2-Gigabit Disk Enclosure (DAE2) Hardware Reference
  • Dell DAE2 | Setup Guide - Page 5
    2. If you are connecting the DAE2 to a storage device such as a CX-Series storage processor enclosure (SPE), make sure the device is installed in the cabinet and set up. Refer to the Setup Guide or Hardware Reference for the device. 3. If you will use EMC ControlCenter Navisphere Manager to monitor
  • Dell DAE2 | Setup Guide - Page 6
    suggest that you number enclosures consecutively. Refer also to the illustrations on page 5 and page 6. Step 2 Set Up Fibre Channel Loops Connect multiple DAE2s in loops. NOTE A Fibre Channel loop is sometimes called a bus. Cable the expansion connector (EXP) of one DAE2 to the primary connector
  • Dell DAE2 | Setup Guide - Page 7
    Step 2 Set Up Fibre Channel Loops (continued) The example configuration below shows two redundant DAE2 loops connected to a Storage Processor Enclosure (SPE). Loop 0 LCC B LCC A EA1/Loop 1 Loop 0 Loop 1 Loop 0 Loop 1 Loop 0 EA1/Loop 0 EA0/Loop 1 EA0/Loop 0 EXP PRI EXP PRI BE1 BE0 SP B
  • Dell DAE2 | Setup Guide - Page 8
    Channel Loops (continued) The illustration below shows an example storage-system configuration with two redundant DAE2 loops segregated above and below the SPE. LCC B Loop 0 SPS B Loop 1 EA4/Loop 0 LCC A EA3/Loop 0 EA2/Loop 0 EA1/Loop 0 Loop 0 EA0/Loop 0 SP B SP A EA0/Loop 1 SPS A EA1
  • Dell DAE2 | Setup Guide - Page 9
    end of a copper cable into the primary (PRI) High Speed Serial Data Connector (HSSDC) connector on each Link Control Card (LCC) in the DAE2. b. Plug the other end of the cables into the appropriate connector on the storage device. Refer to the Setup Guide or the Hardware Reference for the device
  • Dell DAE2 | Setup Guide - Page 10
    each DAE2 power supply. 2. Connect the other end of each ac power cable to the nearest power outlet in the cabinet. For high availability, connect the power supplies to opposing side power strips so they do not share a single circuit. The highly available configuration example shown above supports
  • Dell DAE2 | Setup Guide - Page 11
    DAE2 is correctly cabled, the enclosure addresses are correct, and the disks are completely seated. Then refer to the fault code explanations in Chapter 3 of the DAE2 Hardware Reference. If you cannot determine any reasons for errors, contact your DAE2 service provider. (If you have an EMC service
  • Dell DAE2 | Setup Guide - Page 12
    -system configurations • Configuration planning EMC Fibre Channel Storage System CX-Series Configuration and Planning Guide • Hardware component installation or maintenance EMC 2-Gigabit Disk Enclosure (DAE2) Hardware Reference Storage Processor Hardware Reference(s) as appropriate. • Managing
  • Dell DAE2 | Setup Guide - Page 13
    If You Need Help . For questions about technical support and service, contact your service provider. If you have an EMC service contract, contact EMC Customer Service at USA (800) 782-4362, Canada (800) 543-4782, or worldwide (508) 497-7901. For questions about upgrades, contact your local sales
  • Dell DAE2 | Setup Guide - Page 14
    12
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
EMC Corporation
171 South Street
Hopkinton, MA 01748-9103
Corporate Headquarters
: (508) 435-1000, (800) 424-EMC2
Fax
: (508) 435-5374
Service
: (800) SVC-4EMC
EMC
2-Gigabit Disk Enclosure (DAE2)
SETUP GUIDE
P/N 014003104
REV A01