D-Link DSL-24MF Specifications

DSL-24MF

ADSL Microfilter

ADSL devices such as ADSL modems and routers share a common telephone line with conventional analog telephone, fax

machines,

answering machines and other analog telephony devices. It is necessary to install a low pass filter to block the

higher

frequency channels used to deliver DSL services for every

telephone or POTS (Plain Old Telephone Service) device

that shares the line with the ADSL equipment.

Various Protections Provided

For POTS voice band service, the low pass filter provides

protection from ADSL signals which may impact through

non-line or other effects remote devices (handset, fax,

voice band modem, etc.) and central office operation. For

ADSL signals, it also provides protection from high

frequency transients and impedance effects that occur

during POTS operation (ringing transient, on-hook, off-

hook transient and so on). Because the microfilter

connects directly on the subscriber loop media, it must

also provide some protection for externally induced line

hits or faults which could damage any attached equipment

or endanger human interacting with the installed

equipment. The circuit protection will be provided mostly

by standard central office line protection means and

additional protection measures built into POTS

filter to protect against line over-stress which could

damage the filter itself.

For ADSL G.lite System

For Use With POTS Device Only

Easy Installation

The DSL-24MF in-line ADSL microfilter is specifically

designed to implement the functionality of low pass filter in

G.lite system. G.lite technology is similar to full rate ADSL

that uses the DMT technology, but operates at a lower data

rate of up to 1.5Mbps downstream and 512Kbps upstream,

depending on line conditions and lengths.

The DSL-24MF in-line ADSL microfilter is intended for use

with POTS devices only. Do not install this filter between an

ADSL device and the phoneline wall socket.

The DSL-24MF in-line ADSL microfilter easily connects to

any telephone, G3 fax machine, answering machine and

other POTS devices through an RJ-11 phoneline connector.

The other RJ-11 connector on the DSL-24MF connects to a

wall socket. No configuration

is needed.

RJ-11 Connector - Insert into wall socket

RJ-11 port - Attach to telephone cable