D-Link DMC-300SC User Guide
D-Link DMC-300SC - Media Converter - External Manual
 |
UPC - 790069241802
View all D-Link DMC-300SC manuals
Add to My Manuals
Save this manual to your list of manuals |
D-Link DMC-300SC manual content summary:
- D-Link DMC-300SC | User Guide - Page 1
10/100BASE-TX to 100BASE-FX Media Converter User's Guide Rev. 01 (JUN. 2002) 1907M110MM16003 RECYCLABLE - D-Link DMC-300SC | User Guide - Page 2
TABLE OF CONTENTS ... 2 INTRODUCTION 3 ABOUT MEDIA CONVERTER 3 PRODUCT FEATURES 3 INSTALLATION 4 SELECTING A SITE FOR THE EQUIPMENT 4 CONNECTING TO POWER 5 SLIDING SWITCH 5 CONNECTING TO POWER 6 INSTALLING IN A CHASSIS 6 LED INDICATOR 7 SPECIFICATIONS 8 RECYCLABLE Rev. 01 (Jan. 2002 - D-Link DMC-300SC | User Guide - Page 3
Media Converter The Media Converter is a network technology specified by IEEE 802.3 10BASE-T, IEEE802.3u 100BASE-TX, 100BASE-FX standards. Product Features One-channel media conversion between 10/100BASE-TX and 100BASE-FX Fiber media allows: multi-mode fiber using SC, LC or MT-RJ connector; single - D-Link DMC-300SC | User Guide - Page 4
gives step-by-step installation instructions for the Converter. Selecting a Site for the Equipment As with any electric device, you should place the equipment where it will not be subjected to extreme temperatures, humidity, or electromagnetic interference. Specifically, the site you select should - D-Link DMC-300SC | User Guide - Page 5
power voltage of 7.5Vdc/1.5Amp to the receptacle on the rear panel of the converter, and then attach the plug into a standard AC outlet with a voltage range from 100 to 260 Vac. Sliding Switch There is a sliding switch for duplex mode setting for fiber port. Refer to the table below for more details - D-Link DMC-300SC | User Guide - Page 6
slots on a special designed chassis. First, install the converter onto a carrier supplied with the chassis: Step 1- Unscrew and pull out the media converter board. Step 2- Plug in the media board to any of the vacant slot. Step 3- Fit the converter onto the carrier and use the screw to secure it - D-Link DMC-300SC | User Guide - Page 7
give you instant feedback on status of the converter: LEDs Power (PWR) 100 Mbps (100) TX Port (TX) FX Port (FX) FDX/COL TX Port (TX) FX Port (FX) LINK/ACT State Steady Off Steady Off Steady (FDX) Lights off Blinking (COL) Steady (LINK) Lights off Blinking (ACT) Indication Power on Power - D-Link DMC-300SC | User Guide - Page 8
Per Unit- (2 LEDs): Power; Speed( 100 ) Per Port- (2 LEDs): FDX/COL, LINK/ACT 10BASE-T - 2-pair UTP Cat. 3,4,5, up to 100 m (328 ft) 100BASE-TX -2-pair UTP Cat. 5, up to 100 m (328 ft) 100BASE-FX -62.5/125um multi-mode fiber optic cable, up to 2 km 10/125um single-mode fiber optic cable, up to 75 km
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
10/100BASE-TX to
100BASE-FX
Media Converter
User’s Guide
Rev. 01 (JUN. 2002)
1907M110MM16003
RECYCLABLE