D-Link 1226G User Manual

D-Link 1226G - DES Switch Manual

Get D-Link 1226G - DES Switch PDF manuals and user guides
UPC - 790069264221
View all D-Link 1226G manuals
Add to My Manuals
Save this manual to your list of manuals

D-Link 1226G manual content summary:

  • D-Link 1226G | User Manual - Page 1
    D-Link™ DES-1226G Web-Smart 24-Port 10/100Mbps+2-Port Combo 10/100/1000Mbps Copper/SFP(Mini GBIC) Gigabit Switch Manual First Edition Building Networks for People RECYCLABLE
  • D-Link 1226G | User Manual - Page 2
    Setup Setting...14 Port Settings ...14 VLAN Settings (Virtual Local Area Network 15 Trunk Setting ...15 Mirror Setting ...15 Device Status...16 System Setting...16 Trap Setting ...16 Set Password...17 Backup Setting...17 Reset Setting ...17 5. Technical Specifications 18 Warranty Information
  • D-Link 1226G | User Manual - Page 3
    Installation Guide CD-Rom with Web Management Utility and Manual If any of the above items are missing, please contact your reseller. 2. Introduction Congratulations on your purchase of the DES-1226G 24-Port 10/100Mbps+2-Port combo 10/100/1000Mbps Copper/SFP(Mini GBIC) Gigabit Smart Switch. This
  • D-Link 1226G | User Manual - Page 4
    location and can communicate as if a common broadcast domain, a LAN. The primary utility of using VLAN is to reduce latency and the need for routers, by using faster switching instead. Other VLAN utilities include: Security: Security is increased with the reduction of opportunity in eavesdropping on
  • D-Link 1226G | User Manual - Page 5
    Easy configuration via Web Browser Easy setting via Web Management Utility Standard 19" Rack-mount size LEDs LED stands for Light-Emitting Diode. The front panel LEDs provides instant status feedback and simplifies monitoring and troubleshooting tasks. LED indicators of the Switch Power On When
  • D-Link 1226G | User Manual - Page 6
    port is connected to a 10Mbps Ethernet network, or no link. Ports 25 & 26 Status LEDs Link/Act On When the LED lights on, the respective port operate in half- and full- duplex transfer modes. These ports also support automatic MDI/MDI-X crossover detection, giving true "plug and play"
  • D-Link 1226G | User Manual - Page 7
    10cm (about 4 inches) of space at the front and rear of the Switch for ventilation. Install the DES-1226G on a sturdy, level surface that can support its weight, or in an EIA standard-size equipment rack. When installing the Switch on a level surface, attach the rubber feet to the bottom of each
  • D-Link 1226G | User Manual - Page 8
    as VLAN, Trunking, QoS... etc. Using the Switch's Web Management Utility, you can easily discover all the D-Link Web-Smart Switches in your network, assign the IP Address, change the password, and upgrade new firmware. Installing the Web Management Utility The following gives instructions guiding
  • D-Link 1226G | User Manual - Page 9
    Figure 1. Web Management Utility The Web Management Utility is divided into four parts, Discovery List, Monitor List, Device Setting, and Toolbar function. For detailed instruction, follow the section below. Discovery List This is the list where you can discover all the D-Link Web-Smart devices in
  • D-Link 1226G | User Manual - Page 10
    Note: In order to receive Trap information, the Switch has to be configured with Trap IP and Trap Events in Web browser, available in the Trap Setting Menu (see Page 40 for details). Add Item: To manually add a device to the Monitor List, enter the IP Address of the device that you want to monitor
  • D-Link 1226G | User Manual - Page 11
    of the Monitor List to the default. When you open the Web Management Utility next time, it will automatically load the default recorded setting. Monitor Save As: To record the setting of the Monitor List in appointed filename and file path. Monitor Load: To manually load the setting file of the
  • D-Link 1226G | User Manual - Page 12
    (VLAN) Trunking Port Mirroring System Setting Device status Login Before you configure this device, note that when the Web-Smart Switch is configured through an Ethernet connection, the manager PC must be set on same the IP network. For example, when the default network address of the default IP
  • D-Link 1226G | User Manual - Page 13
    Figure 10. Setup menu 13
  • D-Link 1226G | User Manual - Page 14
    selections. Flow Control: This setting determines whether or not the Switch will be handling flow control. Set FlowCtrl to Enable to avoid data transfer overflow. It is set to Disable when there is either no flow control or other hardware/software management. When the port is set to forced mode, the
  • D-Link 1226G | User Manual - Page 15
    to the device with a same VLAN group. Mirror Setting Port Mirroring is a method of monitoring network traffic that forwards a copy of each incoming and/or outgoing packet from one port of a network switch to another port where the packet can be studied. It enables the manager to keep close track of
  • D-Link 1226G | User Manual - Page 16
    you must re-login to Web Smart Utility before you set the Utility. Fill up the IP Address, Subnet Mask, and Gateway for the device. Figure 17. Trap Setting The Trap Setting enables the device to monitor the Trap through the Web Management Utility and set the Trap IP Address of the manager where the
  • D-Link 1226G | User Manual - Page 17
    used to secure Web Management Switch. Use this function to change the password. If you forget the password, press the "Reset" button in the rear panel of the Switch. The current settings, including VLAN, Port Setting... etc., will be lost and the Switch will restore to the default setting. Figure
  • D-Link 1226G | User Manual - Page 18
    Figure 22. Logout 5. Technical Specifications General Standards Protocol Data Transfer Rate IEEE 802.3 CUL Performance Transmits Method Store-and-forward RAM Buffer 512K bytes per device Filtering Address + Table 6K bytes per device Packet Filtering/ 10Mbps Ethernet: 14,880/pps
  • D-Link 1226G | User Manual - Page 19
    Any hardware, software, firmware or other products or services provided by anyone other than D-Link; Products that have been purchased from inventory clearance or liquidation sales or other sales in which D-Link, the sellers, or the liquidators expressly disclaim their warranty obligation pertaining
  • D-Link 1226G | User Manual - Page 20
    WARRANTY SERVICE, OR ARISING OUT OF ANY BREACH OF THIS LIMITED WARRANTY, EVEN IF D-LINK HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. THE SOLE REMEDY FOR A BREACH OF THE FOREGOING LIMITED WARRANTY Copyright© 2002 by D-Link Corporation/DLink Systems, Inc. All rights with the instructions, may
  • D-Link 1226G | User Manual - Page 21
    mailing/shipping/insurance prepaid. D-Link shall never be responsible for any software, firmware, information, or memory data of Purchaser contained in, stored on, or integrated with any product returned to D-Link pursuant to this warranty. Any package returned to D-Link without an RMA number will
  • D-Link 1226G | User Manual - Page 22
    update which may otherwise be provided free of charge. D-Link's sole obligation under this software warranty shall be to replace any defective software product with product which substantially conforms to D-Link's applicable product documentation. Purchaser assumes responsibility for the selection
  • D-Link 1226G | User Manual - Page 23
    Registration Register your product on-line at: http://support.dlink.com/register Product registration is entirely voluntary and failure to complete or return this form will not diminish your warranty rights. 25
  • D-Link 1226G | User Manual - Page 24
    hardware, software, firmware or other products or services provided by anyone other than D-Link; and Products that have been purchased from inventory clearance or liquidation sales or other sales in which D-Link, the sellers, or the liquidators expressly disclaim their warranty obligation pertaining
  • D-Link 1226G | User Manual - Page 25
    LINK FOR WARRANTY SERVICE) RESULTING FROM THE USE OF THE PRODUCT, RELATING TO WARRANTY SERVICE, OR ARISING OUT OF ANY BREACH OF THIS LIMITED WARRANTY, EVEN IF D-LINK and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However,
  • D-Link 1226G | User Manual - Page 26
    URL: www.dlink.de France Le Florilege #.2, Allee de la Fresnerie 78330 Fontenay le Fleury France TEL: 33-1-30238688 FAX: 33-1-30238689 URL: www.dlink-france.fr -12-665-2165 FAX: 27-12-665-2186 URL: www..d-link.co.za India Russia D-Link House, Kurla Bandra Complex Grafsky per., 14, floor 6 Road
  • D-Link 1226G | User Manual - Page 27
    , S-167 15 Bromma Sweden TEL: 46-(0)8564-61900 FAX: 46-(0)8564-61901 URL: www.dlink.se Denmark Naverland 2, DK-2600 Glostrup, Copenhagen, Denmark TEL: 45-43-969040 FAX: 45-43-424347 URL:www.dlink.dk URL: www.dlink.com.tr Egypt 19 El-Shahed Helmy, El Masri Al-Maza, Heliopolis Cairo,Egypt. TEL
  • D-Link 1226G | User Manual - Page 28
    was purchased from: Reseller's name Telephone Fax Reseller's full address Answers to the following questions help us to support your product: 1. Where and how will the product primarily be used? Home Office Travel Company Business Home Business Personal Use 2. How many employees work at
  • D-Link 1226G | User Manual - Page 29
    29
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
D-Link™
DES-1226G
Web-Smart 24-Port 10/100Mbps+2-Port Combo 10/100/1000Mbps
Copper/SFP(Mini GBIC) Gigabit Switch
Manual
First Edition
Building Networks for People
RECYCLABLE