Campbell Scientific CSAT3 CSAT3 Packing Information

CSAT3 Packing Information

The CSAT3 components are placed in a foam cutout that helps protect them from damage during shipment.

The

CSAT3 should look like the picture below.

After unpacking, it is recommended to save the foam cutout as the CSAT3

components should be placed in the foam cutout whenever the CSAT3 is transported to another location.

Printed 3/7/2012

Place the CSAT3 electronics

box in the cutout, with the

text facing up, and the

connectors pointing away

from the center of the case.

Neatly coil and store the

CSAT3 head cable.

Make sure

the cable will not be pinched

when the case lid is closed.

Underneath the circular foam

cutout are the following items:

(2) #17492 U-bolts with Nuts

(4) #4365 Washers

(2) #9786 Tension Brackets

(1) CM250 Leveling Mounting Kit

(1) Analog Output Cable, 25 ft

(1) RS-232 Output Cable, 25 ft

(1) Power/SDM Cable, 25 ft

Place the CSAT3 head into

the bottom half of the case,

with the text side facing up.