Adaptec 5325301841 User Guide

Adaptec 5325301841 - Snap Server 4500 NAS Manual

Get Adaptec 5325301841 - Snap Server 4500 NAS PDF manuals and user guides
UPC - 753253018413
View all Adaptec 5325301841 manuals
Add to My Manuals
Save this manual to your list of manuals

Adaptec 5325301841 manual content summary:

  • Adaptec 5325301841 | User Guide - Page 1
    with ample room to the front and rear. Removing the Top Cover and SCSI Card 1 Remove the top cover of the Snap Server by turning the cover retention the back of the server counterclockwise until it becomes loose. Field Service Documentation 1 Copyright © 2009, Overland Storage, Inc. All rights
  • Adaptec 5325301841 | User Guide - Page 2
    SCSI card is installed, remove the card and set it aside. Avoid contact with metal surfaces on the card. Installing the SAS Card and Reinserting the SCSI Card PCI cards the SAS card from its protective packaging. Avoid contact with metal surfaces on the card. 2 Field Service Documentation
  • Adaptec 5325301841 | User Guide - Page 3
    SCSl card to the upper (PCI) slot, grasp only the edges of the card and press firmly until it snaps into place. • If you do not have a SCSI card, be Replace the Snap Server in the rack and reconnect the cables. Field Service Documentation 3 Copyright © 2009, Overland Storage, Inc. All rights
  • Adaptec 5325301841 | User Guide - Page 4
    Installing a SAS HBA Card Restoring Power to the Server 1 If you disconnected the Ethernet cable(s), reattach them to the server. 2 Connect the power cord. 3 Press the power button on the front of the server. Snap Server 4500 4 Field Service Documentation Copyright © 2009, Overland Storage, Inc.
  • 1
  • 2
  • 3
  • 4
Field Service Documentation
1
Snap Server 4500
Copyright © 2009,
Overland Storage, Inc. All rights reserved. Information in this document is subject to change without notice and does
not represent a commitment on the part of Overland Storage or any of its subsidiaries.
Installing a SAS HBA Card
The SAS HBA card is required for connectivity to an S50 expansion array.
Caution
There are static-sensitive electronics inside the unit. Before you handle any
parts, make sure you are working at a static-controlled workstation and that you are
properly grounded.
Shutting Down the Server
Power down the server before you make any repairs.
Improper shutdown may lead to
loss of data or physical harm.
1
To start the shutdown process, press the power
button on the front of the server.
The green power LED remains lit until the shutdown
process is complete.
DO NOT
disconnect the AC
power cord while the LED remains lit.
2
After the power LED is off, disconnect the AC power cord(s) and all other cables
from the back of the server.
3
The server is heavy. With the help of an assistant, remove the server from the
rack to a clean surface with ample room to the front and rear.
Removing the Top Cover and SCSI Card
1
Remove the top cover of the Snap Server by turning the cover retention screw at
the back of the server counterclockwise until it becomes loose.