Adaptec 5325301508 Instruction Manual
Adaptec 5325301508 - Snap Server 4400 NAS Manual
 |
View all Adaptec 5325301508 manuals
Add to My Manuals
Save this manual to your list of manuals |
Adaptec 5325301508 manual content summary:
- Adaptec 5325301508 | Instruction Manual - Page 1
4400 Snap Server® 4400 SCSI Card These instructions explain how to install a SCSI card on the Snap Server 4400 from a rack to access to the back panel, disconnect the Ethernet cable(s). Field Service Documentation 1 Copyright © 2009, Overland Storage, Inc. All rights reserved. Information in - Adaptec 5325301508 | Instruction Manual - Page 2
cover back about 1 inch. 3 Lift off the cover and set it aside. Installing the SCSI Card 1 Press the release lever down and forward to release it. Back of server 2 Field Service Documentation Copyright © 2009, Overland Storage, Inc. All rights reserved. Information in this document is subject - Adaptec 5325301508 | Instruction Manual - Page 3
the SCSI card. Press firmly to until the card snaps into place, indicating that it is seated properly in its slot. Avoid contact with metal surfaces on the card. Grasp or press the edges only. Back of server 4 Pull the release lever back into place to secure the card. Field Service Documentation - Adaptec 5325301508 | Instruction Manual - Page 4
Snap Server® 4400 SCSI Card Snap Server 4400 Replacing the Cover 1 Lower the top cover power cord. 3 Press the power button on the front of the server. Power button 4 Field Service Documentation Copyright © 2009, Overland Storage, Inc. All rights reserved. Information in this document is subject
-
1 -
2 -
3 -
4
 |
 |
Field Service Documentation
1
Snap Server 4400
Copyright © 2009,
Overland Storage, Inc. All rights reserved. Information in this document is subject to change without notice and does
not represent a commitment on the part of Overland Storage or any of its subsidiaries.
Snap Server
®
4400 SCSI Card
These instructions explain how to install a SCSI card on the Snap Server 4400.
Shutting Down the Server
Caution
Shut down the server before you make any repairs.
Improper shutdown may
lead to loss of data or physical harm.
1
To start the shutdown process, press the power button on the front of the server.
The green power LEDs remains lit until the
shutdown process is complete. Do not disconnect
the AC power cord while the LED remains lit.
2
After the power LED is off, disconnect the AC power cord from the back of the
server.
3
If you need to remove the server from a rack to access to the back panel,
disconnect the Ethernet cable(s).
Power button