Adaptec 39320A-R Installation Guide
Adaptec 39320A-R - SCSI Card Storage Controller U320 320 MBps Manual
 |
UPC - 760884155257
View all Adaptec 39320A-R manuals
Add to My Manuals
Save this manual to your list of manuals |
Adaptec 39320A-R manual content summary:
- Adaptec 39320A-R | Installation Guide - Page 1
INSTALLATION GUIDE ADAPTEC SCSI CARD 39320A - Adaptec 39320A-R | Installation Guide - Page 2
up to 30 SCSI devices-such as very large arrays of high-performance hard disk drives, external storage subsystems, Ultra320/160 hard disk drives, scanners, and CD-ROM drives-to any Intel-based computer with 64- or 32-bit PCI/PCI-X expansion slots. The Adaptec SCSI Card 39320A has two independent - Adaptec 39320A-R | Installation Guide - Page 3
. This allows the Adaptec SCSI Card 39320A to dedicate one SCSI channel to support a slower transfer rate for the Ultra (legacy) devices, while the second SCSI channel can support LVD devices in Ultra320, Ultra 160, or Ultra2 speeds. It also allows you to use longer cable lengths for the newer - Adaptec 39320A-R | Installation Guide - Page 4
the power cord, remove the cover from the computer. 3 Locate an unused 64-bit PCI/PCI-X expansion slot and remove the expansion slot cover. If the computer does not have a 64-bit slot, you can install the card in a 32-bit PCI slot. The Adaptec SCSI Card 39320A supports both 5V and 3.3V 64-bit slots - Adaptec 39320A-R | Installation Guide - Page 5
several things you may need to do to your SCSI devices before you connect them to the Adaptec SCSI Card 39320A: s Check the SCSI IDs s Set the termination s Connect the power cables Since setup can vary from device to device, always refer to the device's documentation for specific instructions. 4 - Adaptec 39320A-R | Installation Guide - Page 6
Ultra320/160 or Ultra2 cable and terminator before installing the Ultra320/160 SCSI devices. Connecting SCSI Devices You can connect a total of 30 SCSI devices to the Adaptec SCSI Card 39320A, with up to 15 devices on each SCSI channel. Before connecting devices, be sure to review Setting Up SCSI - Adaptec 39320A-R | Installation Guide - Page 7
twisted pairs of the flat ribbon cable between the device connectors. Some cables are laminated so that they lay flat. Internal LVD cables usually have a terminator built into the end of the cable. The Adaptec SCSI Card 39320A has two separate Ultra320/160 SCSI channels, as shown in the figure - Adaptec 39320A-R | Installation Guide - Page 8
this connector Note: Internal Ultra320/160 and Ultra2 SCSI devices come from the factory with termination disabled and cannot be changed. Proper termination is provided by the terminator at the end of the LVD SCSI cable. 4 Connect a power cable from your computer's internal power supply to each - Adaptec 39320A-R | Installation Guide - Page 9
with the newer Ultra320/160 and Ultra2 SCSI devices on the same SCSI channel of the Adaptec SCSI Card 39320A. Follow these steps to connect your external SCSI devices: 1 Connect one end of an external SCSI cable to one of the external Ultra320/160 connectors on the Adaptec SCSI Card 39320A. 68-pin - Adaptec 39320A-R | Installation Guide - Page 10
device(s) and to the computer. More Information About Termination The last SCSI device on the end of each SCSI bus cable must be terminated, and termination must be disabled for all other devices in the middle of the cables. Ultra320/160 and Ultra2 SCSI devices are automatically unterminated - Adaptec 39320A-R | Installation Guide - Page 11
computer manufacturer. No further action is necessary to install the driver. Embedded Adaptec Drivers Some operating systems have embedded driver support for the Adaptec SCSI Card 39320A. To determine if the card is supported by the operating system you are using, read the operating system manual - Adaptec 39320A-R | Installation Guide - Page 12
preparation of this document to assure its accuracy, Adaptec, Inc. assumes no liability resulting from errors and used in accordance with the instruction manual, may cause harmful interference to radio properly grounded I/O cable and power cable to ensure compliance of this unit to the specified - Adaptec 39320A-R | Installation Guide - Page 13
. Adaptec, Inc. Adaptec SCSI Card 39320A Tested 3 V - EN61000-4-11 (1994) Supply dips and variation: 30% and 100% In addition, all equipment requiring U.L. listing has Control Council for Interface). This equipment is designed for home use but it may causes radio frequency interference problem - Adaptec 39320A-R | Installation Guide - Page 14
R Adaptec, Inc. 691 South Milpitas Boulevard Milpitas, CA 95035 USA © 2003 Adaptec, Inc. All rights reserved. Adaptec and the Adaptec logo are trademarks of Adaptec, Inc. which may be registered in some jurisdictions. Part Number: 513666-06, Ver. AA JG 08/03
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
 |
 |
A
DAPTEC
SCSI C
ARD
39320A
I
NSTALLATION
G
UIDE