2008 Toyota Sienna Owners Manual - Page 279

08 SIENNA_U (L/O 0801) However, once the vehicle−to−vehicle distance control mode activates and is used, it cannot be changed to the conventional cruise control mode using the above operation. To change the mode, press the "ON−OFF" button to turn the system off and then press it again to turn it on. Next push the lever in the "MODE" direction for longer than about 1 second. To change to the vehicle−to−vehicle distance control mode from the conventional cruise control mode, push the lever in the "MODE" direction for longer than about 1 second. TURNING THE SYSTEM ON AND OFF To turn the conventional cruise control mode on, turn the "ON−OFF" button on. The "CRUISE" and "READY" indicator lights on the instrument panel will come on. Push the lever in the "MODE" direction for longer than 1 second to change to conventional cruise control mode. The indicator on the instrument panel is as shown. You can now set the cruising speed. Pressing the "ON−OFF" button again turns the system off. When the system is turned off, cruising speed must be reset when the conventional cruise control mode is turned on again. SETTING THE CRUISING SPEED The transmission must be in "D" or "4" before you set the cruising speed. Bring your vehicle to the desired speed, push the lever down in the " − SET" direction and release it. This sets the vehicle at that speed and the display shows the preset speed. You can now take your foot off the accelerator pedal. If you need to accelerate-for example, when passing-depress the accelerator pedal enough for the vehicle to exceed the preset speed. When you release the accelerator pedal, the vehicle will return to the speed set prior to acceleration. CAUTION To avoid accidentally engaging the cruise control, turn the system off when it is not in use. Make sure the "CRUISE" indicator light is off. 238 2008 SIENNA from Aug. '08 Prod. (OM45455U)