2008 Toyota Sienna Owners Manual - Page 241

2008 Toyota Sienna Manual

Page 241 highlights

08 SIENNA_U (L/O 0801) If the light is flashing, we recommend that you replace the engine oil at an early opportunity depending on the driving and road conditions. If the light comes on, replace it as soon as possible. The system must be reset after the engine oil replacement. Reset the system by the following procedure: 1. Turn the engine switch to the "ACC" or "LOCK" position with the odometer reading shown. (For details, see "Odometer and two trip meters" on page 190 in this Section.) 2. Turn the engine switch to the "ON" position while holding down the trip meter reset button. Hold down the button for at least 5 seconds. The odometer indicates "000000" and the light goes off. If the system fails to reset, the light will continue flashing. (o) Third Seats Buzzer Warning Light and (p) Dynamic Laser Cruise Control Master Warning Light This light warns that there is a problem somewhere in the dynamic laser cruise control system. The light will come on when the engine switch is turned to "ON" and go off after a few seconds. When the light comes on, the alarm sounds and the warning code will appear on the display. At this time, dynamic laser cruise control is cancelled. For details, see "Dynamic laser cruise control" on page 225 in Section 1 −7. (q) Key Reminder Buzzer This buzzer acts as a reminder to remove the key when you open the driver's door with the engine switch in the "ACC" or "LOCK" position. "3RD SEAT" warning light (instrument cluster)- This light warns that the third seat operation is not yet complete. Complete the third seat operation. For details, see "-Folding third seats" on page 98 or "-Stowing third seats" on page 101 in Section 1−3. Third seats warning light and buzzer (switch)- This light warns that the third seat operation is not yet completed. When flashing-An object may be caught between the seat and seatback. When illuminated-An object may be caught between the seat and floor or switch is released during the operation. Remove the object and then operate again. If nothing is caught when flashing, contact your Toyota dealer. 200 2008 SIENNA from Aug. '08 Prod. (OM45455U)

We apologize, but we cannot currently deliver this PDF manual by request of the manufacturer.

We apologize for any inconveniece.