1996 Toyota 4Runner Owners Manual - Page 79

Manual transmission ! CAUTION While the vehicle is moving, never attempt to move the selector lever into "P" position under any circumstances. Serious mechanical damage and loss of vehicle control may result. (f) Good driving practice S If the transmission is repeatedly upshifted and downshifted between third gear and overdrive when climbing a gentle slope, the overdrive switch should be turned off. Be sure to turn the switch on immediately afterward. S When towing a trailer, in order to maintain engine braking efficiency, do not use overdrive. NOTICE Do not hold the vehicle on an upgrade with the accelerator pedal. It can cause the transmission to overheat. Always use the brake pedal or parking brake. (g) Driving in "PWR"(Power) mode In the "PWR" mode, the transmission is shifted up and down at a higher vehicle speed than in the "NORM" (Normal) mode and a more powerful acceleration is achieved. To set the "PWR" mode, push in the driving pattern selector button. The "PWR" mode indicator light comes on. For ordinary driving, Toyota recommends using the "NORM" mode to improve fuel economy. (h) If you cannot shift the selector lever out of "P" position If you cannot shift the selector lever from the "P" position even though the brake pedal is depressed, use the shift lock override lever. For instructions, see "If you cannot shift automatic transmission selector lever" in Part 4. The shift pattern is as shown above. Press the clutch pedal down fully while shifting, and then release it slowly. Do not rest your foot on the pedal while driving, because it will cause clutch trouble. And do not use the clutch to hold the vehicle when stopped on an uphill grade-use the parking brake. ! CAUTION Always keep your foot on the brake pedal while stopped with the engine running. This prevents the vehicle from creeping. 73