2012 Buick LaCrosse Owner's Manual - Page 41

Keys, Doors, and Windows 2. Wait for 10 minutes until the DIC displays PRESS ENGINE START BUTTON TO LEARN and then press the ignition. The DIC displays will again show REMOTE LEARN PENDING, PLEASE WAIT. 3. Repeat Step 2 two additional times. After the third time, all previously known transmitters will no longer work with the vehicle. Remaining transmitters can be relearned during the next steps. The DIC display should now show READY FOR REMOTE # 1. 4. Place the new transmitter into the transmitter pocket. The transmitter pocket is located inside the center console storage area under the cupholder. The cupholder will need to be pulled out to access the transmitter pocket. 5. Press the ignition. When the transmitter is learned the DIC will show that it is ready to program the next transmitter. 6. Remove the transmitter from the transmitter pocket and press K. To program additional transmitters, repeat Steps 4 through 6. When all additional transmitters are programmed, press and hold the ignition for 10 seconds to exit programming mode. To start the vehicle: 2-7 Starting the Vehicle with a Low Transmitter Battery If the transmitter battery is weak, the DIC may display NO REMOTE DETECTED when you try to start the vehicle. The REPLACE BATTERY IN REMOTE KEY message may also be displayed at this time. 1. Remove the cupholder from the center console storage area. 2. Place the transmitter in the transmitter pocket with the buttons facing up. 3. With the vehicle in P (Park) or N (Neutral), press the brake pedal and the START/STOP button. See Starting the Engine on page 9‑20 for additional information about the vehicle's keyless ignition with pushbutton start. Replace the transmitter battery as soon as possible.