Home » Weed Eater Manuals » Lawn & Garden » Weed Eater RTE115C » Manual Viewer

Weed Eater RTE115C Owner Manual

Weed Eater RTE115C Manual

View all Weed Eater RTE115C manuals

Add to My Manuals
Save this manual to your list of manuals

Weed Eater RTE115C manual content summary:

Weed Eater RTE115C | Owner Manual - Page 1
votre produit en ligne à l'adresse : www.weedeater.com Instruction Manual Manual de Instrucciones Manuel d'Instructions ESPAÑOL RTE115C WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. Read instructions carefully before assembling. Failure to do so
Weed Eater RTE115C | Owner Manual - Page 2
who read, understand, and follow unit and manual warnings and instructions. Never allow children to operate this unit. Close attention is necessary when used near children. DANGER: Never use blades or flail- ing devices. Unit is designed for line trimmer use only. Use of any other accessories or
Weed Eater RTE115C | Owner Manual - Page 3
inch (1.65 mm) diameter recommended trimmer line (see USER REPLACEABLE SERVICE PARTS in the SERVICE AND ADJUSTMENTS section). Never use wire, rope, string, etc. S Use specified trimmer spool. Make sure spool is properly installed and all parts are securely fastened. S Use only WEED EATER replacement
Weed Eater RTE115C | Owner Manual - Page 4
onto bolt. 5. Adjust the handle up or down the tube to a comfortable position; tighten wing nut securely. Assist handle Trigger housing Tube ATTACHING EDGE GUIDE AND SHIELD WARNING: The shield must be prop- erly installed. The shield provides partial protection to the operator and others from
Weed Eater RTE115C | Owner Manual - Page 5
controls and adjustments. Save this manual for future reference. Trigger Switch Assist Handle Cord Retainer Recessed Plug Locking Sleeve Assembly Twist and Edge Button Motor Housing Air Vents Edge Guide Debris Shield Line Limiter Blade Trimmer Head with 0.065 inch Trimmer Line RECESSED
Weed Eater RTE115C | Owner Manual - Page 6
and keeps the unit from contacting the ground. Take extra caution while edging as objects can be thrown from the trimmer line. Edging SCALPING The scalping technique removes unwanted vegetation. Hold the bottom of the trimmer head about 3 inches (8 cm) above the ground and at an angle. Allow the tip
Weed Eater RTE115C | Owner Manual - Page 7
, the operator must maintain unit as instructed in this manual. Various adjustments will need to be made periodically to properly maintain your unit. BEFORE EACH USE CHECK FOR LOOSE FASTENERS AND PARTS S Housing Screws S Locking Sleeve Assembly S Assist Handle S Debris Shield S Edge Guide CHECK FOR
Weed Eater RTE115C | Owner Manual - Page 8
and place line in slot. Allow line to extend 4 -- 6 inches (10 -15 cm) from center of spool. 4. Ensure line remains in slot while screwing cap on to the shaft. Only tighten cap hand tight! Spool USER REPLACEABLE SERVICE PARTS REPLACEMENT PART Spool with 0.065 inch Trimmer Line Line Guide Ring Cap
Weed Eater RTE115C | Owner Manual - Page 9
mm) dia. line. 2. Replace with correct spool. 3. Cut with tip of line fully extended. 1. Check line routing. 2. Replace spool. 1. Check line routing. 2. Replace spool. 3. Cut with tip of line fully extended. 4. Replace spool. 1. Remove cover and pull 4 inches (10 cm) of line outside of head. 2. Use
Weed Eater RTE115C | Owner Manual - Page 10
recommended by WEED EATER for this product. Additionally, this warranty does not cover parts that will wear and require replacement with reasonable use during the warranty period. This warranty does not cover predelivery set--up or normal adjustments explained in the instruction manual. Should you